- إنضم
- 8 فبراير 2018
- المشاركات
- 1,433
- مستوى التفاعل
- 782
- النقاط
- 113
السلام عليكم
بعد محاولة تخطي حساب google على cm2mt2 باختيار موديل gionee و (gn3001)
انطفأ الهاتف؟
إذا كان هناك من مرّ عليه المشكل يتحفنا بالحل جزاكم الله خيرا.
العملية التي حدثت معي :
بعدها محاولة تخطي google
.
بعد محاولة تخطي حساب google على cm2mt2 باختيار موديل gionee و (gn3001)
انطفأ الهاتف؟
إذا كان هناك من مرّ عليه المشكل يتحفنا بالحل جزاكم الله خيرا.
العملية التي حدثت معي :
1. Make sure device is powered off. Power off, if need. Wait 20 seconds after
2. Insert usb cable in phone
waiting for device connection ...
Ptfn : Preloader usb vcom port (com4)
mode : Preloader port
port : 4
waiting boot ack ...
Preloader : Ack confirmed!
Brom : Init brom
brom init passed!
Chip : Mt6755 , sbid : 0x8a00 , hwvr : 0xcb00 , swvr : 0x0001
type : Modern raphael
brom : Seclevel : 0x00000000
brom : Secmode : Plain [+prl]
brom : Preloader port
mode : Gionee : Gn3001 | manual : Disabled
agent : Look for suitable bootchain in da ...
Agent : Da_pl_crypto.bin
agent : Found mt6755
agent : Mtk_download_agent
brom : Sending 1st da ...
Brom : Da sent
brom :transfer control to da ...
Da : Agent started!
Da : Setup hw params failed! Proto_ver is old?
Error : Fail to init protocol!
Check and select correct settings for your device!
Reconnect power/cable!
بعدها محاولة تخطي google
operation : Reset settings/format fs [ v2.00 r4 ]
1. Make sure device is powered off. Power off, if need. Wait 20 seconds after
2. Insert usb cable in phone
waiting for device connection ...
Ptfn : Da usb vcom port (com5)
mode : Preloader port
port : 5
waiting boot ack ...
Preloader : Ack confirm fail!
Brom : Init brom
error : Fail to init protocol!
Remove battery, cable. Check cable/connection/driver! Check sw hint! Repeat operation!
Reconnect power/cable!
.