حصريا تم حل مشكل تفليش c8 و بدون نزع الذاكرة
الحمد لله تم الحل و بعد معاناة مع هذا الهاتف العنيد الذي لا يقبل التفليش عبر USB
تم ايجاد نقاط التوصيل مباشرة (ISP DIRECT) و بدون الحاجة الى نزع الذاكرة
مع العلم ان الهاتف ارهقني كثيرا ولكن بفضل الله تم الحل
صادفني مشكل غريب اثناء تصليح الذاكرة و هو ان الذاكرة تقلصت من 8GB الئ 4GB
و بعد جهد تمت كسر حماية الذاكرة و تغيير سعة الذاكرة من جديد
و هذا لوغ عملية التصليح
كود:
Welcome to Octoplus Pro JTAG Software version 1.5.8.
Started.
Reader #0: FT SCR2000 0
Reader #1: FT SCR2000 1
Reader #2: FT SCR2000 2
Reader #3: Generic Usb Smart Card Reader 0
Reader #4: Generic Usb Smart Card Reader 1
Please disconnect battery and USB cable.
Model Settings:
Interface : eMMC
Voltage : 3.3V
Bus Mode : 1 bit
Bus speed : Auto
Connecting...
Device : Hynix eMMC H4G1d
Page size : 512 B
Block size : 512 B
Block count : 7634944
Size : 3728.00 MB
---------------------------------------------------------------
CID Info
CID : 90014A4834473164040501A20CA8A185
Manufacturer ID : 0X90
Device/BGA : BGA (Discrete embedded)
OEM/Application ID : 0X4A
Product name : H4G1d
Product revision : 0.5
Product serial number : (hex) 1A20CA8
Manufacturing date : 10/2014
---------------------------------------------------------------
CSD Info
CSD : D02701320F5903FFFFFFFFEF8A4040D3
CSD structure : CSD version No. 1.2
SPEC version : 4.1, 4.2, 4.3, 4.4, 4.41, 4.5,
4.51, 5.0, 5.01, 5.1
Data read access time1: 15 ms
TRAN speed : 26 MHz
READ block length : 512 Bytes
WP group enable : YES
PERM_WRITE_PROTECT : NO
TMP_WRITE_PROTECT : NO
---------------------------------------------------------------
EXTCSD Info
Revision 1.6 (for MMC v4.5, v4.51)
Erase block size : 512 Kbytes
Boot1 size : 4096 Kbytes
Boot2 size : 4096 Kbytes
RPMB size : 4096 Kbytes
Partition config : (0x48) 01001000
Boot partition enable : Boot partition 1
(Bus width = 1Bit)
Boot ACK : Boot acknowledge sent during boot operation Bit
Boot bus conditions : (0x00) 00000000
Boot bus width : x1 (sdr) or x4 (ddr) bus width in boot operation mode (default)
Reset boot bus conditions : Reset bus width to x1, single data rate and backward compatible timings after boot operation (default)
Boot mode : Use single data rate + backward compatible timings in boot operation (default)
RST_n function : (0x01) RST_n signal is permanently enabled
Partitioning support : Device supports partitioning features
Enhanced attribute : Device can have enhanced technological features in partitions and user data area.
Max enhanced data size: 1908736 Kbytes
Partitions attribute : 0x0
Part setting completed: 0x0
GP partition 1 size : 0 b
GP partition 2 size : 0 b
GP partition 3 size : 0 b
GP partition 4 size : 0 b
Enhanced area size : (0x0) 0 b
Enhanced area start : (0x0) 0 b
---------------------------------------------------------------Searching Android build info...
Not found
---------------------------------------------------------------
Backup EXT_CSD saved to file C:/Program Files (x86)/Medusa Pro Software/EXT_CSD Backups/H4G1d_07_05_2018_20_31_21.bin.
Connect successful.
---------------------------------------------------------------
SW: 1.5.8; FW: 1.23.
P00: EXT2FS (001ABA00, 00071000) 226 MB
P01: EXT2FS (00004800, 00005000) 10 MB
P02: EXT2FS (00009800, 00005000) 10 MB
P03: EXT2FS (0001BA00, 00190000) 800 MB
EXT_CSD saved to file C:/Users/STARKRIMES/Desktop/C6/EXT_CSD_07_05_2018_20_31_53.bin.
Switched to boot area partition 1.
Opening C:/Users/STARKRIMES/Desktop/C6/BOOT1 Hynix eMMC H4G1d_07_05_2018_20_32_25.bin file...
Reading. Please wait... Done.
Elapsed time 00:00:01
SW: 1.5.8; FW: 1.23.
Switched to boot area partition 2.
Opening C:/Users/STARKRIMES/Desktop/C6/BOOT2 Hynix eMMC H4G1d_07_05_2018_20_32_43.bin file...
Reading. Please wait... Done.
Elapsed time 00:00:01
SW: 1.5.8; FW: 1.23.
---------------------------------------------------------------
Selected scatter file: E:/FLASH TELEPHONE/Condor/Mobile/C/C8/MT6589__CONDOR__PHS-601__phs601__4.2.1__ALPS.JB2.MP.V1.2/MT6589_Android_scatter_emmc.txt.
Scatter file type 1.
Opened input file: E:/FLASH TELEPHONE/Condor/Mobile/C/C8/MT6589__CONDOR__PHS-601__phs601__4.2.1__ALPS.JB2.MP.V1.2/preloader_phs601.bin
Found 4 eMMC supported CID:
eMMC Vendor ID : 15 (Samsung eMMC)
eMMC Model ID : 0001
eMMC Name : KUS00M
eMMC CID : 1501004B555330304D
eMMC Vendor ID : 90 (Hynix eMMC)
eMMC Model ID : 4A01
eMMC Name : H8G2d
eMMC CID : 90014A483847326404
eMMC Vendor ID : 45 (Sandisk eMMC)
eMMC Model ID : 0001
eMMC Name : SEM08G
eMMC CID : 45010053454D303847
eMMC Vendor ID : 15 (Samsung eMMC)
eMMC Model ID : 0001
eMMC Name : K7XVMB
eMMC CID : 1501004B3758564D42
Writing. Please wait...
Write data verification is enabled.
Writing partition PRELOADER... Write data verification is enabled.
Done.
Writing partition MBR... Done.
Writing partition EBR1... Done.
Writing partition UBOOT... Done.
Writing partition BOOTIMG... Done.
Writing partition RECOVERY... Done.
Writing partition SEC_RO... Done.
Writing partition LOGO... Done.
Writing partition EBR2... Done.
Writing partition ANDROID... Done.
Writing partition CACHE... Done.
Writing partition USRDATA... Done.
Writing checksums...Done.
Writing finished.
SW: 1.5.8; FW: 1.23.
Disconnected.
Please disconnect battery and USB cable.
Model Settings:
Interface : eMMC
Voltage : 3.3V
Bus Mode : 1 bit
Bus speed : Auto
Connecting...
Device : Hynix eMMC H4G1d
Page size : 512 B
Block size : 512 B
Block count : 7634944
Size : 7.28 GB
---------------------------------------------------------------
CID Info
CID : 90014A4834473164040501A20CA8A185
Manufacturer ID : 0X90
Device/BGA : BGA (Discrete embedded)
OEM/Application ID : 0X4A
Product name : H4G1d
Product revision : 0.5
Product serial number : (hex) 1A20CA8
Manufacturing date : 10/2014
---------------------------------------------------------------
CSD Info
CSD : D02701320F5903FFFFFFFFEF8A4040D3
CSD structure : CSD version No. 1.2
SPEC version : 4.1, 4.2, 4.3, 4.4, 4.41, 4.5,
4.51, 5.0, 5.01, 5.1
Data read access time1: 15 ms
TRAN speed : 26 MHz
READ block length : 512 Bytes
WP group enable : YES
PERM_WRITE_PROTECT : NO
TMP_WRITE_PROTECT : NO
---------------------------------------------------------------
EXTCSD Info
Revision 1.6 (for MMC v4.5, v4.51)
Erase block size : 512 Kbytes
Boot1 size : 4096 Kbytes
Boot2 size : 4096 Kbytes
RPMB size : 4096 Kbytes
Partition config : (0x48) 01001000
Boot partition enable : Boot partition 1
(Bus width = 1Bit)
Boot ACK : Boot acknowledge sent during boot operation Bit
Boot bus conditions : (0x00) 00000000
Boot bus width : x1 (sdr) or x4 (ddr) bus width in boot operation mode (default)
Reset boot bus conditions : Reset bus width to x1, single data rate and backward compatible timings after boot operation (default)
Boot mode : Use single data rate + backward compatible timings in boot operation (default)
RST_n function : (0x01) RST_n signal is permanently enabled
Partitioning support : Device supports partitioning features
Enhanced attribute : Device can have enhanced technological features in partitions and user data area.
Max enhanced data size: 1908736 Kbytes
Partitions attribute : 0x0
Part setting completed: 0x0
GP partition 1 size : 0 b
GP partition 2 size : 0 b
GP partition 3 size : 0 b
GP partition 4 size : 0 b
Enhanced area size : (0x0) 0 b
Enhanced area start : (0x0) 0 b
---------------------------------------------------------------Searching Android build info...
Not found
---------------------------------------------------------------
Backup EXT_CSD saved to file C:/Program Files (x86)/Medusa Pro Software/EXT_CSD Backups/H4G1d_07_05_2018_23_01_24.bin.
Connect successful.
---------------------------------------------------------------
SW: 1.5.8; FW: 1.23.
P00: EXT2FS (00020C00, 00190000) 800 MB
P01: EXT2FS (001B0C00, 0003F000) 126 MB
P02: EXT2FS (001EFC00, 00380000) 1792 MB
P03: EXT2FS (00006800, 00005000) 10 MB
P04: EXT2FS (0000B800, 00005000) 10 MB
P05: EXT2FS (00016C00, 00003000) 6 MB
ملاحظة : ملف التصليح معدل و مبرمج مباشرة لكسر حماية الذاكرة وتصليح سعة الذاكرة
بعد كتابة ملف التصليح اعد التفليش بفلاشة خاصة بC8
الملف قيد الدراسة عند الفريق
و شكرا
رد مع اقتباس
المشاركة الأصلية كتبت بواسطة lyes_albert
