Thanks for reply!
it is true there is no cut on the GND, but I did a test as following the pattern of the cable, it does not work for me. when I connect the cable to the PC, I get device not recognized.
I recreated the cable on a pcb with a 56k resistor, as you can see from the photo. Pin 2, where the resistance is connected only needs to be connected to gnd or must have a follow-on USB male?
You can take a look at the cable created?
GND=Black
D+= White
D-= Blue
+5V= REd
Green is Pin 2 (but I do not know if it has to be connected with the resistance on the gnd or also must be connected in usb cable the male?
Thank you.