ممكن مساعدة n7000 بوت

محمد أمين

عضو أساسي
إنضم
27 مايو 2013
المشاركات
318
مستوى التفاعل
128
النقاط
0
عند عمل ريبرى بوت لجلاكسى نود 1 وكل شئ متوصل كويس
تظهر الرسالة دى Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.51
Selected Resurrector: [Samsung N7000 V1.0.4860.58267]

Connecting to the dead ****...OK
Detected dead **** ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.79V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048

No Resurrection Data is available for the eMMC Chip with Capacity = 0B
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 14.68GB

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.


مع الحل يا شباب
 

himihicham

عضو أساسي
إنضم
25 فبراير 2013
المشاركات
296
مستوى التفاعل
316
النقاط
0
الإقامة
maroc
رد: ممكن مساعدة n7000 بوت

المشكل في البروس اما انه معطل يجب تغيره او غير مدعوم
 

himihicham

عضو أساسي
إنضم
25 فبراير 2013
المشاركات
296
مستوى التفاعل
316
النقاط
0
الإقامة
maroc
رد: ممكن مساعدة n7000 بوت

WARNING: DCC Loader was unable to initialize FLASH1 chip.

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000000



This error is returned by DCC loader in case that memory chip is not detected. Usually it hapens when chip it self is dead, or it's not powered.



User should replace memory chip, or in rare cases check power supply circuitry.

Tags: -




http://forum.gsmhosting.com/vbb/f634/i9100-error-code-0x00000048-1622099/
 
أعلى