السلام عليكم و رحمة و بركاته
خاوتي راح نشري الفولكانو واش رايكم
خاوتي راح نشري الفولكانو واش رايكم
Phone found! [ 28 ]
Port Opened
Sync...
InitBoot Done [ 0x81 ] , Ver : SPRD3
Sync...
Sending FDL
[Info] : If SW freeze here more, than 15 seconds - remove cable
PickUp loaders from pac
FDL Ready!
Boot Ver : Spreadtrum Boot Block version 1.1
Sending FLASH FDL
FLASH FDL Ready!
Boot Ok!
FlashMode Set : Error Init FL mode!
Checking Structure ...
Unknown structure detected! Something went wrong
If phone work normally - check correct selection (Model,FlashType)!
Elapsed: 00:00:16
Reconnect Power/Cable!
Operation : Check/Read Info [ v1.15 ]
Normal
Normal , 1 : Power On phone. Insert USB cable ( Normal USB cable )
Service
Service , 1 : Insert USB cable ( Use adapter or special cable )
Service , 2 : Insert battery
Service , 3 : If boot not start - press 'Power' button shortly
==== Wait for phone...
Phone found! [ 264 ]
Port Opened
Sync...
InitSvc Done
Wait for phone...
Sync...
Phone Initial Info :
Platform : MOCORTM_14B_W15.24_Debug
Project : sc7731g_CP0_modem
HWInfo : sc7731g_CP0_modem
Compile : 07-28-2015 11:08:42
Phone Security Info :
IMEI [1] : 86947
IMEI [2] : 86947
BT_ADDR : 000000000000
Done
Reconnect Power/Cable!
كي نحب نقرا لفلاشة المشكل في الصورة
نفس المشكل أخي العزيزجرب نسخة الاخيرة بتاريخ 07 مارس
Infinity Chinese Miracle-2 SPD/Spreadtrum v1.16
""
Some bugfixes and improvements
Some improvements and bugfixes at all
""
صحيح هناك مشكلة في قراءة الفلاشة مع SC7730 و SC7731 خاصة ادا كان Android 5.1
إن كنت ستشتريها لأجل أجهزة spd فلا داعي
يوجد مثلا cs-tool على حسب الأراء أنه يتعامل جيدا مع هذا المعالج spd
حسان علاش تخسر روحك متشريش ..كي تحتاجها قولي لانو متستعملهاش دائما مدام عندك الانفينيتي